LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 271 (Engine Mechanical - 4.8L, 5.3L, 6.0L Or 6.2L (4 Of 5)) >> Off-Vehicle Repair Instructions (2 Of 3) >> Camshaft and Bearings Cleaning and Inspection (RPO LY2/LC9/LY5/LMG) >> Measuring Camshaft Lobe Lift

Measuring Camshaft Lobe Lift

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Measuring Camshaft Lobe Lift
    GM64967Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Measuring camshaft lobe lift is a procedure used to determine if the camshaft lobes have worn. This test is to be performed prior to engine disassembly and with the camshaft and valve train components installed in the engine.
  1. Using the J 8520  , measure camshaft lobe lift. See Special Tools .
  2. Remove the valve rocker arms and bolts.
  3. Install the dial indicator mounting stud into the valve rocker arm bolt hole.
  4. Assemble the components of the J 8520  and position onto the stud. See Special Tools .
  5. Position the shaft of the dial indicator onto the end of the pushrod.
  6. Rotate the face of the dial indicator to zero.
  7. Slowly rotate the crankshaft clockwise, until the dial indicator obtains its highest and lowest readings.
  8. Compare the total to specifications. Refer to Engine Mechanical Specifications (RPO LY2 VIN C) or Engine Mechanical Specifications (RPO LMG VIN 0) or Engine Mechanical Specifications (RPO LY5 VIN J) or Engine Mechanical Specifications (RPO LC9 VIN 3) or Engine Mechanical Specifications (RPO L76 VIN Y) or Engine Mechanical Specifications (RPO LY6 VIN K) or Engine Mechanical Specifications (RPO L92 VIN 8) .
scientia non olet · About LEMON Manuals