LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 268 (Rear Suspension System) >> Repair Instructions >> Rear Axle Upper Control Arm Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Support the vehicle at curb height.
  3. Disconnect the electronic suspension control (ESC) sensor, if equipped. Refer to Electronic Suspension Rear Position Sensor Replacement - Left Side or Electronic Suspension Rear Position Sensor Replacement - Right Side .
    4. Fig 1: View Of Upper Control Arm-To-Frame Bracket Retaining Nut & Bolt
    GM516277Courtesy of GENERAL MOTORS CORP.
  4. Remove the upper control arm retaining nut and bolt from the frame bracket.
    5. Fig 2: View Of Upper Control Arm-To-Axle Bracket Retaining Nut & Bolt
    GM516271Courtesy of GENERAL MOTORS CORP.
  5. Remove the upper control arm retaining nut and bolt from the axle bracket.
  6. Remove the upper control arm.
scientia non olet · About LEMON Manuals