Electronic Suspension Rear Position Sensor Replacement - Right Side

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Electronic Suspension Position Sensor & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . Remove the right rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
1	Electrical Connector
2	Position Sensor Servo Arm Bracket Bolt NOTE: Refer to Fastener Notice . Tighten: 17 N.m (13 lb ft)
3	Position Sensor Bracket Bolt Tighten: 12 N.m (106 lb in)
4	Electronic Suspension Position Sensor