LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 268 (Rear Suspension System) >> Repair Instructions >> Rear Axle Upper Control Arm Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the upper control arm.
    2. Fig 1: View Of Upper Control Arm-To-Axle Bracket Retaining Nut & Bolt
    GM516271Courtesy of GENERAL MOTORS CORP.
  2. Install the upper control arm retaining bolt and nut to the axle bracket.
    3. Fig 2: View Of Upper Control Arm-To-Frame Bracket Retaining Nut & Bolt
    GM516277Courtesy of GENERAL MOTORS CORP.
  3. Install the upper control arm retaining bolt to the frame bracket.
    4. NOTE: Refer to Fastener Notice .
    IMPORTANT: Do not tighten the nuts unless the suspension is at the curb height position.
  4. Install the upper control arm retaining nut.

    Tighten:  Tighten the upper control arm retaining bolts to 160 N.m (118 lb ft).

  5. Connect the ESC sensor, if equipped. Refer to Electronic Suspension Rear Position Sensor Replacement - Left Side or Electronic Suspension Rear Position Sensor Replacement - Right Side .
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals