LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 259 (Front Drive Axle) >> Repair Instructions >> Front Drive Axle Clutch Shaft Bearing Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the inner axle shaft and housing assembly. Refer to Front Drive Axle Inner Shaft and Inner Shaft Housing Replacement (8.25 S4WD and 9.25 Axles)  or Front Drive Axle Inner Shaft and Inner Shaft Housing Replacement (8.25 F4WD) .
  2. Remove the clutch shaft from the differential carrier assembly.
    3. Fig 1: Identifying Clutch Shaft Pilot Bearing - Front Drive Axle
    GM680254Courtesy of GENERAL MOTORS CORP.
  3. Remove the clutch shaft pilot bearing using the J 34011  . See Special Tools .
scientia non olet · About LEMON Manuals