Front Differential Case Assemble (8.25 Inch Axle): Assemble

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Lubricate the pinion and side gears using axle lubricant. Use the correct fluid. Refer to Adhesives, Fluids, Lubricants, and Sealers .

Fig 1: Differential Side Gears & Thrust Washers

Courtesy of GENERAL MOTORS CORP.

Install the thrust washers and the differential side gears into the differential case.
If the same differential side gears and the thrust washers are being used, install the gears and the washers to the original locations.

Fig 2: Identifying Differential Pinion Gears & Thrust Washers

Courtesy of GENERAL MOTORS CORP.

Install the differential pinion gears by performing the following steps:
1. Position both pinion gears between the differential side gears directly opposite of each other.
2. Rotate the differential side gears until the pinion gears are opposite the opening in the differential case in line with the pinion shaft opening.
Install the thrust washers.
Rotate the pinion gears toward the differential case opening in order to permit the sliding in of the thrust washers.

Fig 3: View Of Differential And Pinion Shaft

Courtesy of GENERAL MOTORS CORP.

Install the pinion gear shaft.
Install the new pinion gear shaft lock pin using a hammer and a brass drift.

Fig 4: Ring Gear & Differential Case

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: The mating surface of the ring gear and the differential case must be clean and free of burrs before installing the ring gear.

Install the ring gear onto the differential case.

Fig 5: Identifying Ring Gear Bolts

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: The ring gear bolts have left-hand threads.

Install the new ring gear bolts.
Hand start each bolt to ensure that the ring gear is properly installed to the differential case.

NOTE: Refer to Fastener Notice .

Tighten the ring gear bolts. Tighten the ring gear bolts alternately and in stages, gradually pulling the ring gear onto the differential case.
Tighten: Tighten the ring gear bolts in sequence to 120 N.m (89 lb ft).

Fig 6: Installing Differential Side Bearing

Courtesy of GENERAL MOTORS CORP.

Install the differential side bearings by performing the following steps:
1. In order to protect the differential case, install the J 8107-2 in the case on the side opposite the bearing installation.
2. Install the J 22761 (2) and the J 8092 (1) onto the differential case bearing as shown.
3. Drive the differential case bearing onto the case using the J 22761 and the J 8092 . See Special Tools .