Transfer Case Four Wheel Drive Actuator Lever Shaft Bearing Replacement - Front

WARNING: This page is about a different car, the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Transfer Case Four Wheel Drive Actuator Lever Shaft Bearing Replacement - Front

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Ensure the bearing is installed squarely into the bearing bore.
1	Transfer Case Four Wheel Drive Actuator Lever Shaft Bearing Assembly Tip: Ensure the printing on the bearing is facing upward. A suitable adapter is required to use with J 8092 . Press the bearing until the bearing bottoms on the front case half. Special Tools J 2619-01 Slide Hammer J 8092 Driver Handle J 44737 Shift Rail Bearing Remover. See Special Tools .

Callout

Component Name

Preliminary Procedure:
Ensure the bearing is installed squarely into the bearing bore.

Transfer Case Four Wheel Drive Actuator Lever Shaft Bearing Assembly
Tip:

Ensure the printing on the bearing is facing upward.
A suitable adapter is required to use with J 8092 .
Press the bearing until the bearing bottoms on the front case half.

Special Tools

J 2619-01 Slide Hammer
J 8092 Driver Handle
J 44737 Shift Rail Bearing Remover. See Special Tools .