Front Output Shaft Drive Sprocket Bearing Replacement
WARNING: This page is about a different car, the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Courtesy of GENERAL MOTORS CORP.
| Callout |
Component Name |
|
Preliminary Procedure
- Using the J 35512
and an arbor press, remove the bearing assemblies from the drive sprocket. See Special Tools .
- Ensure the bearings are installed squarely into the drive sprocket bore.
|
| 1 |
Transfer Case Front Output Shaft Drive Sprocket Bearing Assembly - Front
Tip:
- Install the bearing using the long side of the DT-48211
. See Special Tools .
- Ensure the flat edge of the bearing is facing upward.
- Using an arbor press or hammer, install the bearing until the tool bottoms on the drive sprocket.
Special Tools
- DT-48211
Drive Sprocket Bearing Installer. See Special Tools .
- J 8092
Driver Handle
- J 35512
Inner Pinion Bearing Installer. See Special Tools .
|
| 2 |
Transfer Case Front Output Shaft Drive Sprocket Bearing Assembly - Rear
Tip:
- Install the bearing using the short side of the DT-48211
. See Special Tools .
- Ensure the flat edge of the bearing is facing upward.
- Using an arbor press or hammer, install the bearing until the tool bottoms on the drive sprocket.
Special Tools
- DT-48211
Drive Sprocket Bearing Installer. See Special Tools .
- J 8092
Driver Handle
- J 35512
Inner Pinion Bearing Installer. See Special Tools .
|