LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 227 (Automatic Transmission - 2ML70 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Range Selector Lever Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Steering Cable Retainer On Steering Column
    GM1774414Courtesy of GENERAL MOTORS CORP.
  1. Position the steering column shift lever to the park position.
  2. Remove the instrument panel knee bolster. Refer to Knee Bolster Replacement (Except Cadillac) or Knee Bolster Replacement (Cadillac) .
  3. Remove the driver seat. Refer to Front Seat Replacement - Bucket (without HP2) or Front Seat Replacement - Bucket (with HP2) .
  4. Remove the body hinge pillar trim panel. Refer to Body Hinge Pillar Trim Panel Replacement .
  5. Pull back the carpet and insulation around the driver area.
  6. Remove the retainer securing the cable to the steering column.
    7. Fig 2: View Of Cable, Steering Column Ball Stud & Steering Column Bracket
    GM1774419Courtesy of GENERAL MOTORS CORP.
  7. Remove the cable end from the steering column ball stud.
  8. Depress the tangs and remove the cable from the steering column bracket.
    9. Fig 3: View Of Range Selector Cable
    GM1774421Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Avoid unnecessary twisting/bending of the range selector cable when removing the cable from the support.
  9. Remove the range selector cable from the support.
    10. Fig 4: View Of Cable Grommet At Floor Panel
    GM858974Courtesy of GENERAL MOTORS CORP.
  10. Remove the cable grommet from the floor panel.
  11. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    12. Fig 5: View Of Cable Clips At Floor Panel Reinforcement
    GM394470Courtesy of GENERAL MOTORS CORP.
  12. Remove the clips on the cable from the floor panel reinforcement.
  13. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
    14. Fig 6: Range Selector Lever Cable Heat Shield Bolts & Shield
    GM1970183Courtesy of GENERAL MOTORS CORP.
  14. Remove the range selector lever cable heat shield bolts (1).
  15. Remove the range selector lever cable heat shield (2).
  16. Ensure the transmission manual shaft is positioned in mechanical park.
    17. Fig 7: Range Selector Lever Cable
    GM1970184Courtesy of GENERAL MOTORS CORP.
  17. Disconnect the range selector lever cable (2) from the range select lever.
  18. Remove the range selector lever cable retainer (1).
  19. Remove the range selector lever cable (2) from the cable bracket.
scientia non olet · About LEMON Manuals