LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 225 (HVAC System - Automatic) >> Repair Instructions >> Auxiliary Inside Air Temperature Sensor Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the new sensor grille to the headliner.
    2. Fig 1: Inside Air Temperature Sensor
    GM675994Courtesy of GENERAL MOTORS CORP.
  2. Install the inside air temperature sensor to the headliner and sensor grille.
    3. Fig 2: View Of Inside Air Temperature Sensor Electrical Connector
    GM675996Courtesy of GENERAL MOTORS CORP.
  3. Connect the electrical connector to the inside air temperature sensor.
  4. Secure the headliner to the roof hook and loop retainers.
  5. Install the rear headliner retainers to the front headliner.
  6. Install the left rear coat hook, if equipped. Refer to Coat Hook Replacement .
  7. Install the third pillar molding. Refer to Center Pillar Upper Garnish Molding Replacement .
scientia non olet · About LEMON Manuals