Center Pillar Upper Garnish Molding Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Center Pillar Upper Garnish Molding Assembly & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Disable roof rail SIR system. Refer to SIR Disabling and Enabling . Remove center pillar lower garnish molding. Refer to Center Pillar Lower Garnish Molding Replacement .
1	Center Pillar Upper Garnish Molding Cover
2	Center Pillar Upper Garnish Molding Screw NOTE: Refer to Fastener Notice . Tighten: 2 N.m (18 lb in)
3	Center Pillar Upper Garnish Molding Assembly Tip: Remove seat belt D-ring from the adjuster assembly. Pull garnish molding toward inside of the vehicle to disengage the retainers. Align 4-way locator to center pillar before engaging retainers. Tighten: 35 N.m (25 lb ft)
4	Center Pillar Upper Garnish Molding Retainer (Qty: 4)