LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 220 (Engine Mechanical - 4.8L, 5.3L, 6.0L Or 6.2L (2 Of 5)) >> On-Vehicle Repair Instructions (1 Of 2) >> Valve Lifter Replacement (LY2, LY6, L92) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Valve Lifter Guides, Cylinder Head & Bolts
    GM1403318Courtesy of GENERAL MOTORS CORP.
  1. Remove the cylinder head and gasket. Refer to Cylinder Head Replacement - Left Side  or Cylinder Head Replacement - Right Side .
  2. Remove the valve lifter guide bolts (211).
  3. Remove the valve lifter guides (210) with the lifters. Note the installed position of the guides. The notched area of the guides is to align with the locating tab on the engine block.
    4. Fig 2: Valve Lifter Guides & Bolts
    GM1403319Courtesy of GENERAL MOTORS CORP.
  4. Remove the valve lifters (209) from the guide (210).
  5. Organize or mark the components so that they can be installed in the same location from which they were removed, if required.
  6. Clean and inspect the valve lifters, if required. Refer to Valve Lifter and Guide Cleaning and Inspection (RPO LY2/LY6/L92) or Valve Lifter and Guide Cleaning and Inspection (RPO LC9/LY5/LMG/L76) .
scientia non olet · About LEMON Manuals