LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 218 (Power Steering System) >> Repair Instructions >> Rack & Pinion Steering Linkage Inspection >> Outer Tie Rod

Outer Tie Rod

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the outer tie rod seal. If the outer tie rod seal is torn, replace the outer tie rod.
  2. Elevate the left or right front of the vehicle and install a suitable vehicle support, maintaining contact between one front wheel and the shop floor. Refer to Lifting and Jacking the Vehicle .
    3. Fig 1: Identifying J 42640
    GM333146Courtesy of GENERAL MOTORS CORP.
  3. Position the wheels in a straight-ahead position and install anti-rotation pin J 42640  .
    4. Fig 2: Checking Tie Rod-To-Steering Knuckle Lash
    GM1855614Courtesy of GENERAL MOTORS CORP.
  4. Install dial indicator J 8001  between the outer tie rod and steering knuckle as shown and push slowly inward with one hand on the tire to remove the lash.

    The wheel and tire are removed for clarity.

  5. Place the dial indicator at zero, pull outward on the tire, and note the amount of movement in the joint.

    Movement should not exceed 1.0 mm (0.04 in). If movement exceeds 1.0 mm (0.04 in) then replace the outer tie rod.

  6. Repeat steps 3 and 4 for the other side of the vehicle if needed.
  7. If tie rod end replacement is needed, refer to Steering Linkage Outer Tie Rod Replacement .
scientia non olet · About LEMON Manuals