Steering Linkage Outer Tie Rod Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Steering Linkage Outer Tie Rod Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the front tire/wheel. Refer to Tire and Wheel Removal and Installation .
1	Steering Linkage Outer Tie Rod Nut NOTE: Refer to Fastener Notice . Tighten: 60 N.m (44 lb ft)
2	Steering Linkage Inner Tie Rod Nut Tighten: 75 N.m (55 lb ft)
3	Steering Linkage Outer Tie Rod Procedure Use puller J 24319-B to separate the steering linkage outer tie rod from the steering knuckle. See Special Tools . Inspect the steering linkage inner tie rod for bent or damaged threads. Clean the tapered surface of the steering knuckle. Lubricate the steering linkage inner tie rod threads with chassis lubricant. Refer to Fluid and Lubricant Recommendations . Adjust the front toe. Refer to Front Toe Adjustment . Special Tools: J 24319-B Steering Linkage and Tie Rod Puller. See Special Tools .