Door Ajar Indicator Malfunction
WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
Door Ajar Indicator Malfunction
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Interior Lights Schematics Connector End View Reference: Vehicle Access Connector End Views |
|||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle |
| 2 | Open and close the driver and passenger doors one at a time while monitoring the driver information center (DIC) display. Do the door ajar indicators operate properly? |
Go to Testing for Intermittent Conditions and Poor Connections | Go to Step 3 |
| 3 | Do the courtesy lamps operate properly with the opening and closing of each of the doors? | Go to Step 4 | Go to Courtesy Lamps Inoperative |
| 4 | Replace the instrument panel cluster (IPC). Refer to Control Module References
for replacement, setup, and programming. Did you complete the replacement? |
Go to Step 5 | - |
| 5 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 3 |