LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 197 (Wiring Systems And Power Management - Introduction) >> Repair Instructions >> Ignition Lock Cylinder Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to SIR Caution .
  1. Disable the SIR system. Refer to SIR Disabling and Enabling .
  2. Remove the knee bolster. Refer to Knee Bolster Replacement (Except Cadillac) or Knee Bolster Replacement (Cadillac) .
  3. Remove the steering column shroud. Refer to Steering Column Shroud Replacement .
  4. With the key installed hold it in the START position.
    5. Fig 1: View Of Lock Cylinder & Allen Wrench
    GM1413814Courtesy of GENERAL MOTORS CORP.
  5. Install an Allen wrench into the hole on top of the ignition lock cylinder case.

    Push down on the Allen wrench to release the tab on the ignition lock cylinder inside the ignition lock cylinder case.

    6. Fig 2: View Of Lock Cylinder At Lock Cylinder Housing
    GM1413837Courtesy of GENERAL MOTORS CORP.
  6. Slide the ignition lock cylinder out of the ignition lock cylinder case.
scientia non olet · About LEMON Manuals