Steering Column Shroud Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Upper & Lower Steering Column Trim Cover & Tilt Lever

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Tilt Lever Procedure: Remove by pulling straight outwards.
2	Upper Steering Column Shroud
3	Lower Steering Column Shroud NOTE: Refer to Fastener Notice . Procedure If equipped, remove the 2 lower steering column shroud bolts. Install 2 lower steering column shroud bolts if damage exists to the steering column shroud locking features. Tighten: 3 N.m (27 lb in)

Callout

Component Name

Tilt Lever
Procedure:
Remove by pulling straight outwards.

Upper Steering Column Shroud

Lower Steering Column Shroud

NOTE: Refer to Fastener Notice .

Procedure

If equipped, remove the 2 lower steering column shroud bolts.
Install 2 lower steering column shroud bolts if damage exists to the steering column shroud locking features.

Tighten: 3 N.m (27 lb in)