LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 197 (Wiring Systems And Power Management - Introduction) >> Repair Instructions >> Ignition Lock Cylinder Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Screwdriver Being Used To Rotate Lock Cylinder Housing Gear
    GM1413835Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The gears between the ignition/start switch and the ignition lock cylinder case must be in the correct position. Failure to do so will cause a misalignment of the gears in the ignition/start switch and the ignition lock cylinder case, which may result in a NO START or BATTERY DRAIN.
  1. Use a screwdriver to rotate the ignition lock cylinder case gear clockwise to the start position - allowing it to spring return into the RUN position.
    2. Fig 2: View Of Lock Cylinder At Lock Cylinder Housing
    GM1413837Courtesy of GENERAL MOTORS CORP.
  2. Install the key into the ignition lock cylinder.
  3. Align the ignition lock cylinder and install it into the ignition lock cylinder case.
  4. Install the steering column shroud. Refer to Steering Column Shroud Replacement .
  5. Install the knee bolster. Refer to Knee Bolster Replacement (Except Cadillac) or Knee Bolster Replacement (Cadillac) .
  6. Enable the SIR system. Refer to SIR Disabling and Enabling .
scientia non olet · About LEMON Manuals