LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 196 (Engine Cooling System) >> Repair Instructions >> Engine Coolant Fan Motor Replacement (Non-HP2) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Cooling Fan Motor & Bolts
    GM1505517Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the cooling fan motor(s).
  2. Install the cooling fan motor bolts.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  3. Install the cooling fan blades. Refer to Engine Cooling Fan Replacement (Non-HP2)  or Engine Cooling Fan Replacement (HP2) .
scientia non olet · About LEMON Manuals