Rear Side Door Window Reveal Molding Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Side Door Window Reveal Molding & Retainers

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Lower the rear side door window to the fully down position. Tape off the lower window frame to prevent damage to the door. Remove the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement (Standard Wheelbase) or Rear Side Door Trim Panel Replacement (Extended Wheelbase) . Remove the rear door window inner belt sealing strip. Refer to Rear Side Door Window Inner Sealing Strip Replacement . Remove the inside door frame garnish molding.
1	Rear Side Door Window Reveal Molding Retainer (Qty: 12) Tip: If reusing the window reveal molding replace the clips.
2	Rear Side Door Window Reveal Molding Procedure Install the reveal molding into the window opening by inserting the bottom edge of the molding through the belt opening of the door. Allow the integral fasteners and clips to clear the door frame. Use care not to scratch the paint. Fully seat the molding onto the belt flange between the corners. Ensure that the lower attachment clips are aligned the holes in the door frame. Ensure all clips around the window flange are fully seated.

Callout

Component Name

Preliminary Procedures

Lower the rear side door window to the fully down position.
Tape off the lower window frame to prevent damage to the door.
Remove the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement (Standard Wheelbase) or Rear Side Door Trim Panel Replacement (Extended Wheelbase) .
Remove the rear door window inner belt sealing strip. Refer to Rear Side Door Window Inner Sealing Strip Replacement .
Remove the inside door frame garnish molding.

Rear Side Door Window Reveal Molding Retainer (Qty: 12)
Tip: If reusing the window reveal molding replace the clips.

Rear Side Door Window Reveal Molding

Procedure

Install the reveal molding into the window opening by inserting the bottom edge of the molding through the belt opening of the door. Allow the integral fasteners and clips to clear the door frame.
Use care not to scratch the paint.
Fully seat the molding onto the belt flange between the corners. Ensure that the lower attachment clips are aligned the holes in the door frame.
Ensure all clips around the window flange are fully seated.