Rear Side Door Trim Panel Replacement (Extended Wheelbase)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Side Door Trim Panel Assembly & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove rear door window control switch. Refer to Rear Side Door Window Switch Replacement .
1	Rear Side Door Locking Rod Knob Assembly Procedure Lower window. Ensure locking rod is in the unlocked position. Use a flat-bladed tool to disengage detent tab, then remove knob by pulling upward. When re-installing, push knob down, until detent tab touches locking rod opening cover. Push detent tab in to lock knob to locking rod.
2	Rear Side Door Trim Panel Cover
3	Rear Side Door Trim Panel Cover Retainer (Qty: 4)
4	Rear Side Door Inside Handle Bezel Cover
5	Rear Side Door Trim Panel Bolt (Qty: 3) NOTE: Refer to Fastener Notice . Tighten: 9 N.m (18 lb in)
6	Rear Side Door Trim Panel Assembly
7	Rear Side Door Cable Retainer Procedure Depress both tabs to remove cable and pull cable rearward out of handle assembly. When reinstalling cable make sure that it is fully seated past the guide tab.
8	Rear Side Door Trim Panel Retainer (Qty: 10)