Rear Side Door Window Regulator Replacement (Manual)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Side Door Window Regulator & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
CAUTION: Refer to SIR Caution . Preliminary Procedures Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling . Position the rear side door window approximately half way down in the door. Remove the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement (Standard Wheelbase) or Rear Side Door Trim Panel Replacement (Extended Wheelbase) . Remove the rear door water deflector. Refer to Rear Side Door Water Deflector Replacement .
1	Rear Side Door Window Bolt (Qty: 2) NOTE: Refer to Fastener Notice . Tip: Tape the window to the door frame to prevent it from moving. Loosen the 2 bolts that attach the window to the window regulator. Tighten: 9 N.m (80 lb in)
2	Rear Side Door Window Regulator Bolt (Qty: 4) Tighten: 9 N.m (80 lb in)
3	Rear Side Door Window Regulator