LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 189 (Steering Wheel & Steering Column) >> Repair Instructions >> Shift Lever Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the steering column shroud. Refer to Steering Column Shroud Replacement .
  2. Roll back the shift lever seal on the shift lever until the shift lever bolt is exposed.
  3. Disconnect any electrical connectors as needed.
    4. Fig 1: Locating Shift Lever & Screw
    GM1700835Courtesy of GENERAL MOTORS CORP.
  4. Remove the shift lever bolt (2).
  5. Remove the shift lever (1).
scientia non olet · About LEMON Manuals