LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 189 (Steering Wheel & Steering Column) >> Repair Instructions >> Shift Lever Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Shift Lever & Screw
    GM1700835Courtesy of GENERAL MOTORS CORP.
  1. Install the shift lever (1).
    2. NOTE: Refer to Fastener Notice .
  2. Install the shift lever bolt (2).

    Tighten:  Tighten the bolt to 20 N.m (15 lb ft).

  3. Connect all electrical connectors.
  4. Position the shift lever seal.
  5. Install the steering column shroud. Refer to Steering Column Shroud Replacement .
scientia non olet · About LEMON Manuals