LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 186 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Air Conditioning Condenser Replacement (Gas) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Radiator Support Bolts
    GM1987767Courtesy of GENERAL MOTORS CORP.
  1. Recover the refrigerant. Refer to Refrigerant Recovery and Recharging (Non HP2)  or Refrigerant Recovery and Recharging (HP2) .
  2. Remove the fascia.
  3. Remove radiator support bolts (1). Access the bolts from the rear of the upper radiator support. Refer to Radiator Support Replacement .
  4. Remove radiator support bracket bolts (1).
    5. Fig 2: View Of Discharge Hose At Condenser
    GM363062Courtesy of GENERAL MOTORS CORP.
  5. Remove the compressor discharge hose assembly bolt from the condenser.
  6. Disconnect the compressor discharge hose assembly from the condenser.
    7. Fig 3: View Of Evaporator Tube And Condenser (W/O HP2)
    GM363033Courtesy of GENERAL MOTORS CORP.
  7. Remove the evaporator tube nut from the condenser.
  8. Disconnect the evaporator tube from the condenser.
  9. Remove the insulator retainer bolts and the upper insulator retainers.
  10. Remove the condenser from the vehicle.
scientia non olet · About LEMON Manuals