LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 185 (Parking Brake System) >> Repair Instructions >> Parking Brake Rear Cable Replacement - Left Side >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Park Brake Cable & Actuator Lever
    GM1688693Courtesy of GENERAL MOTORS CORP.
  1. Install the cable taking care to correctly route the cable through the guides and the body mounts.
  2. Install the cable to the backing plate by pressing the cable into place until the tabs lock into place.
  3. Install the cable to the actuator lever.
    4. Fig 2: View Of Park Brake Cable, Shock Absorber Bracket & Bolt - Left Rear
    GM555965Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  4. Position the park brake cable to the rear axle bracket and install the bolt and nut (2500 series).

    Tighten:  Tighten the bolt and nut to 22 N.m (16 lb ft).

  5. Position the park brake cable to the cable guides on the vehicle frame.
    6. Fig 3: View of Park Brake Cable & Mounting Bracket
    GM363839Courtesy of GENERAL MOTORS CORP.
  6. Install the cable to the mounting bracket until the tabs lock into place.
    7. Fig 4: View Of Park Brake Cables At Equalizer Bar
    GM1471613Courtesy of GENERAL MOTORS CORP.
  7. Connect the left rear park brake cable (3) to the intermediate park brake cable (1) equalizer.
  8. Lower the vehicle. Refer to Lifting and Jacking the Vehicle .
  9. Enable the park brake cable automatic adjuster. Refer to Parking Brake Cable Adjuster Enabling .
  10. Adjust the park brake. Refer to Park Brake Adjustment .
scientia non olet · About LEMON Manuals