LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 185 (Parking Brake System) >> Repair Instructions >> Parking Brake Indicator Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Park Brake Warning Lamp Switch & Mounting Bolt
    GM913316Courtesy of GENERAL MOTORS CORP.
  1. Install the park brake warning lamp switch.
    2. NOTE: Refer to Fastener Notice .
  2. Install the park brake warning lamp switch bolt.

    Tighten:  Tighten the bolt to 3 N.m (27 lb in).

    3. Fig 2: View Of Park Brake Warning Lamp Switch Electrical Connector
    GM606395Courtesy of GENERAL MOTORS CORP.
  3. Connect the park brake warning lamp switch electrical connector.
  4. Install the left side instrument panel electrical center/junction block. Refer to Instrument Panel Electrical Center or Junction Block Replacement - Left Side .
  5. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About LEMON Manuals