Rear Bumper Fascia Replacement (All Utility, Cadillac ESV)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Bumper Fascia Assembly & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the rear wheelhouse inner panel extensions. Refer to Rear Wheelhouse Panel Liner Replacement (RPO X88 Chevrolet, RPO O88 GMC) or Rear Wheelhouse Panel Liner Replacement (RPO HP2) .
1	Rear Fascia Bolt (Qty: 2) NOTE: Refer to Fastener Notice . Tighten: 9 N.m (80 lb in)
2	Rear Fascia Plastic Bolt (Qty: 3) Procedure Disconnect the rear object detection sensor harness located in the right end of the fascia and any other electrical connectors before attempting removal. Reach between the fascia and the rear quarter panel to loosen the bolts. DO NOT pull on the fascia when reaching to loosen the bolts. Tighten: 9 N.m (80 lb in)
3	Rear Fascia Bolt (Qty: 4) Tighten: 9 N.m (80 lb in)
4	Rear Fascia Plastic Retainer (Qty: 2)
5	Fascia Assembly Tip: If replacing the Z-71 fascia, new fender flare holes will need to be drilled as needed.