Front Upper Fascia Support Bracket Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Front Upper Fascia Support Bracket Assembly & Screws

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement (Escalade) or Front Bumper Fascia Replacement (Tahoe) or Front Bumper Fascia Replacement (Avalanche) or Front Bumper Fascia Replacement (Z71) or Front Bumper Fascia Replacement (Yukon) .
1	Front Upper Fascia Support Bracket Bolt (Qty: 6) NOTE: Refer to Fastener Notice . Tighten: 7 N.m (62 lb in)
2	Front Upper Fascia Support Bracket Assembly Tip: Disconnect the wiring harness retainer from each end if equipped.