Front Bumper Fascia Support Replacement (Chevrolet HP2)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Front Bumper Fascia Support & Bracket Assembly

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the front fascia. Refer to Front Bumper Fascia Replacement (Escalade) or Front Bumper Fascia Replacement (Tahoe) or Front Bumper Fascia Replacement (Avalanche) or Front Bumper Fascia Replacement (Z71) or Front Bumper Fascia Replacement (Yukon)
1	Front Bumper Fascia Support Bolt (Qty: 8) NOTE: Refer to Fastener Notice . Tighten: 7 N.m (62 lb in)
2	Front Bumper Fascia Support Procedure Disconnect any electrical connectors. Transfer parts as needed.

Callout

Component Name

Preliminary Procedure:

Remove the front fascia. Refer to Front Bumper Fascia Replacement (Escalade) or Front Bumper Fascia Replacement (Tahoe) or Front Bumper Fascia Replacement (Avalanche) or Front Bumper Fascia Replacement (Z71) or Front Bumper Fascia Replacement (Yukon)

Front Bumper Fascia Support Bolt (Qty: 8)

NOTE: Refer to Fastener Notice .

Tighten: 7 N.m (62 lb in)

Front Bumper Fascia Support

Procedure

Disconnect any electrical connectors.
Transfer parts as needed.