LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 173 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Hood Primary Latch Release Cable Handle Replacement

Hood Primary Latch Release Cable Handle Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Hood Latch Release Cable & Nut
GM1674991Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedure: 
Remove the body hinge pillar trim panel. Refer to Body Hinge Pillar Trim Panel Replacement .
1 Hood Latch Release Handle Nut
NOTE: Refer to Fastener Notice .

Tighten:  9 N.m (80 lb in)
2 Hood Latch Release Handle
scientia non olet · About LEMON Manuals