LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 173 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Cargo Box Stowage Box Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear compartment cover assembly. Refer to Cargo Box Front Cover, Center Cover, and Rear Cover Replacement .
  2. Remove the assist handle. Refer to Endgate Assist Handle Replacement (Avalanche) .
  3. Remove the cargo box stowage lid assembly. Refer to Cargo Box Stowage Box Lid Replacement .
    4. Fig 1: View Of Body Side Inner Panel Bolts & Cargo Box Stowage Box
    GM1708945Courtesy of GENERAL MOTORS CORP.
  4. Remove the lamp socket from the pickup box side courtesy lamp.
  5. Remove the cargo tie-down bolts and tie rings from the body side inner panel.
  6. Remove the cargo box stowage box (2) from the vehicle.
scientia non olet · About LEMON Manuals