LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 173 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Cargo Box Stowage Box Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Body Side Inner Panel Bolts & Cargo Box Stowage Box
    GM1708945Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the cargo box stowage box (2) to the vehicle.

    Tighten:  Tighten the bolts to 9 N.m (80 lb in).

  2. Install the cargo tie-down rings and bolts to the body side inner panel.

    Tighten:  Tighten the bolts to 9 N.m (80 lb in).

  3. Install the cargo box stowage lid assembly. Refer to Cargo Box Stowage Box Lid Replacement .
  4. Install the lamp socket to the pickup box side courtesy lamp assembly.
  5. Install the assist handle. Refer to Endgate Assist Handle Replacement (Avalanche) .
  6. Install the rear compartment cover assembly. Refer to Cargo Box Front Cover, Center Cover, and Rear Cover Replacement .
scientia non olet · About LEMON Manuals