LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 170 (Wiper System & Washer System) >> Repair Instructions >> Windshield Wiper and Washer Switch Replacement

Windshield Wiper and Washer Switch Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Multifunction Turn Signal Switch & Screws
GM1701070Courtesy of GENERAL MOTORS CORP.
Callout Component Name
CAUTION: Refer to SIR Caution .

Preliminary Procedure

  1. Remove the steering wheel. Refer to Steering Wheel Replacement
  2. Remove the steering column shroud. Refer to Steering Column Shroud Replacement
1 Multifunction Turn Signal Switch Screw (Qty: 2)
NOTE: Refer to Fastener Notice .

Tighten:  3 N.m (27 lb in)

2 Multifunction Turn Signal Switch
Tip: 
  1. The wipers/washer switch is integral to the multifunction turn signal switch.
  2. Disconnect the electrical connectors as needed.