Air Inlet Grille Panel Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Air Inlet Panel & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Remove the fixed antenna, if equipped. Refer to Radio Antenna Replacement (Avalanche/Escalade EXT) . Remove the windshield wiper arms. Refer to Windshield Wiper Arm Replacement (Flat Blade ) or Windshield Wiper Arm Replacement (Conventional) or Windshield Wiper Arm Replacement (Chevrolet Tahoe Two-mode Hybrid) . Remove the rear hood seal. Refer to Hood Rear Seal Replacement .
1	Air Inlet Panel End Panel
2	Air Inlet Panel Retainer (Qty: 2)
3	Air Inlet Panel Screw (Qty: 2) NOTE: Refer to Fastener Notice . Tighten: 9 N.m (80 lb in)
4	Air Inlet Panel Clip
5	Air Inlet Panel