Windshield Wiper Arm Replacement (Chevrolet Tahoe Two-mode Hybrid)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Windshield Wiper Arm (Chevrolet Tahoe Two-mode Hybrid)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Windshield Washer Arm Finish Cap Tip: Lift the cap from the outside edge and rotate the cap forward in order to expose the wiper arm nut.
2	Windshield Washer Arm Nut NOTE: Refer to Fastener Notice . Tip: Hold the wiper blade arm tip to the vertical black bar target mark located at the lower center portion of the windshield while securing the nut. Tighten: 35 N.m (26 lb ft)
3	Windshield Wiper Arm Assembly Procedure Use the J 39637 Wiper Arm Remover Tool. See Special Tools . Transfer the wiper blade to the new windshield wiper arm. Refer to Windshield Wiper Blade Replacement (Flat Blade) or Windshield Wiper Blade Replacement (Conventional) .

Callout

Component Name

Windshield Washer Arm Finish Cap
Tip: Lift the cap from the outside edge and rotate the cap forward in order to expose the wiper arm nut.

Windshield Washer Arm Nut

NOTE: Refer to Fastener Notice .

Tip: Hold the wiper blade arm tip to the vertical black bar target mark located at the lower center portion of the windshield while securing the nut.

Tighten: 35 N.m (26 lb ft)

Windshield Wiper Arm Assembly

Procedure

Use the J 39637 Wiper Arm Remover Tool. See Special Tools .
Transfer the wiper blade to the new windshield wiper arm. Refer to Windshield Wiper Blade Replacement (Flat Blade) or Windshield Wiper Blade Replacement (Conventional) .