Liftgate Center Applique Replacement (Tahoe, Yukon)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Liftgate Center Applique Assembly & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Procedure Open the liftgate. Remove the rear wiper motor. Refer to Rear Window Wiper Motor Replacement . Remove the 4 applique nuts from inside the liftgate panel. Release the 2 integral retainers from the exterior side of the applique.
1	Liftgate Center Applique Assembly Nuts (Qty: 4) NOTE: Refer to Fastener Notice . Tighten: 6 N.m (53 lb in)
2	Liftgate Center Applique Harness Grommet Tip: Ensure the grommet is secure to the liftgate panel hole prior to the installation of the applique.
3	Liftgate Center Applique Assembly Tip: Transfer the rear view camera (if equipped). Refer to Rearview Camera Replacement (Liftgate) or Rearview Camera Replacement (Endgate) .