LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 170 (Wiper System & Washer System) >> Repair Instructions >> Rear Window Wiper Motor Replacement

Rear Window Wiper Motor Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rear Window Wiper Motor
GM1669967Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedures

  1. Remove the liftgate interior trim panel. Refer to Liftgate Trim Panel Replacement .
  2. Remove the rear wiper arm assembly. Refer to Rear Window Wiper Blade Replacement (except Avalanche) .
  3. Remove the rear wiper motor pivot shaft nut and spacer.
1 Rear Window Wiper Motor Assembly Bolt (Qty: 2)
NOTE: Refer to Fastener Notice .

Tip:  Tighten the rear wiper motor pivot shaft nut after the motor and pivot shaft spacer have been installed.

Tighten:  9 N.m (80 lb in)
2 Rear Window Wiper Motor Assembly

Procedure

  1. Pull the wiper motor forward towards the front of the vehicle.
  2. Disconnect the electrical connector.
  3. Remove the rear wiper motor from the inner liftgate panel.
  4. Check the rear wiper shaft spacer upon installation of the new wiper motor to ensure proper position of the spacer to the rear liftgate panel.
scientia non olet · About LEMON Manuals