Liftgate Center Applique Replacement (GMC Yukon Two-mode Hybrid)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Liftgate Center Applique

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Open the liftgate. Remove the rear wiper motor. Refer to Rear Window Wiper Motor Replacement . Remove the 4 applique nuts from inside the liftgate panel. Release the 2 integral retainers from the exterior side of the applique.
1	Liftgate Center Applique Assembly Nut (Qty: 4) NOTE: Refer to Fastener Notice . Tighten: 6 N.m (53 lb in)
2	Integral Retainer (Qty: 2)
3	Rear Liftgate Harness Electrical Connector Tip: Disconnect the electrical connector after releasing the retainers.
4	Liftgate Center Applique Assembly Procedure Pull the applique rearward in order to release the 2 outer integral clips. Transfer the rear view camera (if equipped). Refer to Rearview Camera Replacement (Liftgate) or Rearview Camera Replacement (Endgate) .