LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 162 (Engine Mechanical - 4.8L, 5.3L, 6.0L And 6.2L (5 Of 5)) >> Off-Vehicle Repair Instructions (3 Of 3) >> Valve Lifter Oil Manifold Installation

Valve Lifter Oil Manifold Installation

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Valve Lifter Oil Manifold
    GM1536553Courtesy of GENERAL MOTORS CORP.
  1. Do not lift the manifold assembly by the electrical lead frame.
    2. Fig 2: View Of Outer Gasket
    GM1402014Courtesy of GENERAL MOTORS CORP.
    IMPORTANT:
    • All gasket surfaces should be free of oil or other foreign material during assembly.
    • Do not allow dirt or debris to enter the manifold. Plug, as required.
  2. Install the service gasket (556) onto the manifold.
    3. Fig 3: View Of Valve Lifter Oil Manifold
    GM1402004Courtesy of GENERAL MOTORS CORP.
  3. Install the manifold (451) with gasket.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the manifold bolts (506).

    Tighten:  Tighten the manifold bolts to 25 N.m (18 lb ft).

scientia non olet · About LEMON Manuals