LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 162 (Engine Mechanical - 4.8L, 5.3L, 6.0L And 6.2L (5 Of 5)) >> Off-Vehicle Repair Instructions (3 Of 3) >> Engine Valley Cover Installation

Engine Valley Cover Installation

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Engine Valley Cover Components
    GM1403316Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: All gasket surfaces should be free of oil or other foreign material during assembly.
  1. Lubricate the O-ring seals with clean engine oil.
  2. Install the O-ring seals (537) to the cover (555).
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the cover (555), gasket (556), and bolts (506).

    Tighten:  Tighten the manifold bolts to 25 N.m (18 lb ft).

    4. Fig 2: View Of Oil Pressure Sensor & Washer
    GM1403317Courtesy of GENERAL MOTORS CORP.
  4. Apply sealant GM P/N 12346004 (Canadian P/N 10953480), or equivalent, to the threads of the sensor.
  5. Install the oil pressure sensor (706) and sealing washer (707).

    Tighten:  Tighten the sensor to 35 N.m (26 lb ft).

scientia non olet · About LEMON Manuals