LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 162 (Engine Mechanical - 4.8L, 5.3L, 6.0L And 6.2L (5 Of 5)) >> Off-Vehicle Repair Instructions (3 Of 3) >> Crankshaft Front Oil Seal Installation (RPO LY6/L76/L92) >> Tools Required

Tools Required

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

J 41478  Crankshaft Front Oil Seal Installer. See Special Tools .

    Fig 1: View Of Outer Edge Of The Oil Seal
    GM1658279Courtesy of GENERAL MOTORS CORP.
    IMPORTANT:
    • Do not lubricate the oil seal sealing surface.
    • Do not use the crankshaft front oil seal again.
  1. Lubricate the outer edge of the oil seal (140) with clean engine oil.
  2. Lubricate the front cover oil seal bore with clean engine oil.
    3. Fig 2: View Of Front Oil Seal & Special Tool
    GM1658280Courtesy of GENERAL MOTORS CORP.
  3. Install the crankshaft front oil seal (140) onto the J 41478  . See Special Tools .
  4. Install the J 41478  threaded rod, with nut, washer, guide, and oil seal, into the end of the crankshaft. See Special Tools .
  5. Use the J 41478  in order to install the oil seal into the cover bore. See Special Tools .
    1. Use a wrench and hold the hex on the installer bolt.
    2. Use a second wrench and rotate the installer nut clockwise until the seal bottoms in the cover bore.
    3. Remove the tool.
    4. Inspect the oil seal for proper installation. The oil seal should be installed evenly and completely into the front cover bore.
scientia non olet · About LEMON Manuals