LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 157 (Steering Linkage) >> Repair Instructions >> Pitman Arm Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Pitman Arm, Power Steering Gear, Washer & Nut
    GM398127Courtesy of GENERAL MOTORS CORP.
  1. Raise and suitable support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the power steering gear. Refer to Power Steering Gear Replacement (Rack and Pinion) or Power Steering Gear Replacement (Non Rack and Pinion) .
  3. Install the power steering gear into a vise.
  4. Remove the pitman arm nut and washer.
    5. Fig 2: View Of Pitman Arm, Power Steering Gear (Non Rack and Pinion) & Special Tools
    GM398243Courtesy of GENERAL MOTORS CORP.
  5. Remove the pitman arm from the pitman shaft using J 6632-01  or J 29107-A  .
scientia non olet · About LEMON Manuals