LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 157 (Steering Linkage) >> Repair Instructions >> Pitman Arm Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Pitman Arm, Power Steering Gear, Washer & Nut
    GM398127Courtesy of GENERAL MOTORS CORP.
  1. Install the pitman arm to the power steering gear.
    2. NOTE: Refer to Fastener Notice .
  2. Install a new pitman arm washer and nut.

    Tighten:  Tighten the nut to 250 N.m (184 lb ft).

  3. Remove the power steering gear from the vise.
  4. Install the power steering gear. Refer to Power Steering Gear Replacement (Rack and Pinion) or Power Steering Gear Replacement (Non Rack and Pinion) .
  5. Lower the vehicle.
  6. Check the wheel alignment. Refer to Measuring Wheel Alignment .
scientia non olet · About LEMON Manuals