LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 138 (Shift Interlock System) >> Repair Instructions >> Automatic Transmission Shift Lock Actuator Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Automatic Transmission Shift Lock Control Actuator
    GM324906Courtesy of GENERAL MOTORS CORP.
  1. Disable the SIR system. Refer to SIR Disabling and Enabling .
  2. Remove the knee bolster. Refer to Knee Bolster Replacement (Cadillac) or Knee Bolster Replacement (Except Cadillac) .
  3. Put the shift lever clevis into the neutral position.
  4. Disconnect the electrical connector.
  5. Using a small screwdriver, pry the automatic transmission shift lock control actuator away from the steering column jacket and the cable shift cam.
  6. Remove the shift lock control actuator.
scientia non olet · About LEMON Manuals