LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 124 (Power Steering System) >> Repair Instructions >> Stub Shaft Housing Replacement

Stub Shaft Housing Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Stub Shaft Housing, O-Ring & Bolt
GM1751559Courtesy of GENERAL MOTORS CORP.
Stub Shaft Housing Replacement

Callout Component Name
Preliminary Procedures: 
Remove the power steering gear. Refer to Power Steering Gear Replacement (Rack and Pinion)  or Power Steering Gear Replacement (Non Rack and Pinion) .
1 Stub Shaft Housing Bolt (Qty: 4)
NOTE: Refer to Fastener Notice .

Tighten:  62 N.m (46 lb ft)
2 Stub Shaft Housing
3 Stub Shaft Housing O-Ring (Qty: 2)
Tip:  Grease the stub shaft seals with the special grease supplied in the service kit.
scientia non olet · About LEMON Manuals