LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 124 (Power Steering System) >> Repair Instructions >> Power Steering Cooler Pipe/Hose Replacement (Without Hydroboost) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front grille. Refer to Fascia Grille Replacement (Suburban) or Fascia Grille Replacement (Yukon) or Fascia Grille Replacement (Escalade) or Fascia Grille Replacement (Tahoe Z71) .
  2. Remove the radiator air baffle and deflector-upper. Refer to Radiator Air Upper Baffle and Deflector Replacement (Cadillac) or Radiator Air Upper Baffle and Deflector Replacement (Yukon) .
  3. Remove the radiator grille reinforcement support. Refer to Support Replacement - Radiator Grille Reinforcement .
    4. Fig 1: View Of Power Steering Cooler Hoses & Components (Rack and Pinion)
    GM363050Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Power Steering Hose Disconnected Notice .
  4. Remove the power steering gear outlet hose (4) from the cooler.
  5. Remove the power steering cooler hose from the power steering pump (1).
    6. Fig 2: View Of Power Steering Cooler & Bolts (With Hydroboost)
    GM686121Courtesy of GENERAL MOTORS CORP.
  6. Remove the bolts (2) retaining the cooler to the radiator support.
  7. Remove the power steering cooler from the vehicle.
scientia non olet · About LEMON Manuals