LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 124 (Power Steering System) >> Repair Instructions >> Power Steering Cooler Pipe/Hose Replacement (Without Hydroboost) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Power Steering Cooler & Bolts (With Hydroboost)
    GM686121Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the power steering cooler (1) to the vehicle.

    Tighten:  Tighten the power steering cooler retaining bolts to 9 N.m (80 lb in).

    2. Fig 2: View Of Power Steering Cooler Hoses & Components (Rack and Pinion)
    GM363050Courtesy of GENERAL MOTORS CORP.
  2. Connect the power steering cooler hose to the power steering pump (1) and reposition the clamp.
  3. Connect the power steering gear outlet hose (4) to the cooler.

    Reposition the retaining clamp.

  4. Bleed the power steering system. Refer to Power Steering System Bleeding .
  5. Inspect all the hose connections for leaks.
  6. Install the radiator grille reinforcement support. Refer to Support Replacement - Radiator Grille Reinforcement .
  7. Install the radiator air baffle and deflector-upper. Refer to Radiator Air Upper Baffle and Deflector Replacement (Cadillac) or Radiator Air Upper Baffle and Deflector Replacement (Yukon) .
  8. Install the front grille. Refer to Fascia Grille Replacement (Suburban) or Fascia Grille Replacement (Yukon) or Fascia Grille Replacement (Escalade) or Fascia Grille Replacement (Tahoe Z71) .
scientia non olet · About LEMON Manuals