LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 122 (Front Suspension System) >> Repair Instructions >> Lower Control Arm Replacement (1500 Series) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: The lower ball joint and control arm are serviced as an assembly and are not serviced separately.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Support the lower control arm with a safety stand.
  3. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  4. Remove the stabilizer shaft links from the lower control arm. Refer to Stabilizer Shaft Link Replacement (1500 Series)  or Stabilizer Shaft Link Replacement (2500 Series) .
    5. Fig 1: View Of Lower Shock Absorber Module Mount Bolts
    GM1761077Courtesy of GENERAL MOTORS CORP.
  5. Remove the 2 lower shock absorber module mount bolts.
  6. If equipped, remove the wheel drive shaft nut.
    7. Fig 2: View Of Lower Ball Joint Retaining Nut
    GM1761079Courtesy of GENERAL MOTORS CORP.
  7. Remove the lower ball joint retaining nut.
    8. Fig 3: Separating The Lower Ball Joint From The Steering Knuckle (RWD)
    GM853943Courtesy of GENERAL MOTORS CORP.
  8. Using the J 43631  and the J 45851  , remove the lower ball joint from the steering knuckle. See Special Tools .
  9. Remove the lower control arm nuts and washers.
  10. Remove the control arm bolts.
  11. Remove the control arm.
scientia non olet · About LEMON Manuals