LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 121 (Rear Drive Axle) >> Repair Instructions >> Rear Axle Replacement (15 Series) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the rear axle assembly to the vehicle.
  2. Connect the upper control arm to the rear axle. Refer to Rear Axle Upper Control Arm Replacement in Rear Suspension.
  3. Connect the lower control arm to the rear axle. Refer to Rear Axle Lower Control Arm Replacement in Rear Suspension.
  4. Connect the track bar to the rear axle. Refer to Track Bar Replacement in Rear Suspension.
  5. Install the coil springs. Refer to Coil Spring Replacement in Rear Suspension.
    6. NOTE: Refer to Fastener Notice in Cautions and Notices.
  6. Install the crossover brake pipe to the rear axle.

    Tighten:  Tighten the bolt to 22 N.m (16 lb ft).

  7. Install the stabilizer shaft to the rear axle. Refer to Stabilizer Shaft Replacement in Rear Suspension.
  8. Install the caliper assemblies to the rear axle. Refer to Rear Brake Caliper Replacement (1500 Series) or Rear Brake Caliper Replacement (2500 Series) in Disc Brakes.
  9. Connect the right-rear park brake cable to the rear axle. Refer to Park Brake Cable Replacement - Right Rear in Park Brake.
  10. Connect the left-rear park brake cable to the rear axle. Refer to Park Brake Cable Replacement - Left Rear in Park Brake.
  11. Install the propshaft. Refer to Rear Propeller Shaft Replacement in Propeller Shaft.
  12. Connect the wheel speed sensor connector.
  13. Connect the rear axle vent tube.
  14. Install the tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  15. Fill the axle with lubricant. Use the proper fluid. Refer to Capacities - Approximate Fluid and to Fluid and Lubricant Recommendations in Maintenance and Lubrication.
  16. Remove the utility stands and the jack stands.
  17. Lower the vehicle.
scientia non olet · About LEMON Manuals